|
Post by ironlegs on Aug 16, 2020 0:32:43 GMT
HI Zach
Just trying to print out the Large wooden bridge with buildings on it and noticed that the buildings are floating above the bridge. The print fails because they need to be about 1 mm lower so they touch the bridge.
I'm relative new to this so don't know how to edit the file to correct it.
Any advice would be welcome.
Thanks
Karim
|
|
|
Post by 6mmfan on Aug 18, 2020 8:47:15 GMT
Yes you're right, I can see the gap when I open them in Simplify3d. I guess as a workaround you can print the bridge and buildings separate. I opened it in Tinkercad but it looks like a bit of work to split the pieces up so they can be joined.
|
|
|
Post by suntzu on Aug 18, 2020 11:13:35 GMT
When I get home today I will see if I can repair the model and will put it in the files section
|
|
|
Post by suntzu on Aug 18, 2020 14:59:36 GMT
there is now a replacement file in the files area of this forum
Rob
|
|
|
Post by ironlegs on Aug 18, 2020 22:41:11 GMT
Many Thanks
|
|
|
Post by alce66 on Dec 26, 2020 12:36:09 GMT
there is now a replacement file in the files area of this forum Rob I noticed the same problem with the wood bridge Please, could you tell where is the files area?
|
|
|
Post by suntzu on Dec 26, 2020 12:50:17 GMT
Zach will need to grant you access
|
|